question

stoic avatar image
stoic asked

Multiplus pylontech "DVCC" setting on venusXG

I am using these instructions to configure my pylons with mt three phase MPII setup: https://www.victronenergy.com/live/battery_compatibility:pylontech_phantom


Section 5 mentions a "DVCC" setting, but i am not able to find it on my VenusGX:

Is this a critical part or not? i was able to successfully link my pylons and i even got the battery on my overview screen, it also showed the SOC, all of this without me setting the DVCC to on as i do not have that option.


Should i be worried?

Multiplus-IIPylontechVenus GX - VGX
1547458641807.png (35.2 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
mvader (Victron Energy) avatar image
mvader (Victron Energy) answered ·

Hi!

pls start with firmware updating your venus gx and/or reporting its version here.


You do need the setting.

3 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

stoic avatar image stoic commented ·

The version on my VenusGX is: v2.11

When i click on "check for updates" it says "checking" then it switches back to "Check for updates"

0 Likes 0 ·
mvader (Victron Energy) avatar image mvader (Victron Energy) ♦♦ stoic commented ·

perhaps there is no internet. v2.11 is definitively too old.


Otherwise use the offline method; see docs:

https://www.victronenergy.com/live/ccgx:firmware_updating#microsd-card_or_usb-stick

0 Likes 0 ·
stoic avatar image stoic mvader (Victron Energy) ♦♦ commented ·

I managed to update the software to the latest version using the sd card


0 Likes 0 ·