When I first connected everything the smart dongle showed up on the app but I can’t use it to configure the multiplus somehow.
I tried both port and bought the Victron cable but still not working. Help please!
asked
Help on VE Bus Smart Dongle with multiplus 12/3000/120
The VE Bus smart dongle cannot be used to configure the Multi. It can change some settings and work for basic monitoring.
Here is the manual
https://www.victronenergy.com/live/vebus_smart_dongle_manual
Here are some screenshots of what to expect.
To change settings and program the inverter you need the mk3 to usb adaptor.
Sorry for the confusion, that what I mean to monitoring and to see the AC input on output. Mine doesn’t even show that. When I click it it just show me the battery voltage and temperature. Thank you.
Because you have a Cerbo connected or a remote panel, they become the Master of the Ve.Bus and the dongle looses it's privileges, so it only shows very basic / no useful information.
You can use them, they do not smart network however. So both just independent monitors.
If you touch to open the smart dongle do you see anything like the screenshots in my post above?
Yes I did, I went though everything trying to figure out what happened. On it it said it might take a a little bit to register the multiplus device on the app but it’s been a week now lol. I don’t know what to do now.
Well you definitely were patient with that. I think 10 minutes and I would have been done with it.
Have you tried cutting the power off to the dongle then connecting it again (power cycle). Then maybe a different VE BUS port. Other than that there is not much elese to do except return it.
@Zhao Thomas
At minimum it can be used as temperature and voltage so if it is not even doing that, that is a problem. Did it ask for a firmware update at all.
