Is it possible to configure Venus to accept a VE-Direct connection on the Raspberry Pi built in UART? This is normally configured as /dev/ttyS0 under Raspian, what needs to be configured in Venus to get this to work?
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Is it possible to configure Venus to accept a VE-Direct connection on the Raspberry Pi built in UART? This is normally configured as /dev/ttyS0 under Raspian, what needs to be configured in Venus to get this to work?
Yes it does work on the raspi3B+ with the older ver 2.66 software.
Victron Venus OS Open Source intro page
Venus OS GitHub (please do not post to this)
Additional resources still need to be added for this topic
Raspberry Pi running Victron’s Venus firmware - Blog Post
Venus OS Large image: Signal K and Node-RED - Install
raspberrypi install venus image
49 People are following this question.
how to change settings on the bluesolar mppt connected to venus os raspberry.
Victron VE.direct to usb losing connection on Raspberry Pi
Connect Raspberry Pi directly to MPPT over serial pins for Venus OS / Venus package
Has anyone tried to connect a Lynx Distributor directly to Venus OS?
SmartSolar MPPT 100/20 and a Raspberry Pi 3+ with Venus OS - Device List empty