question

dzm9508 avatar image
dzm9508 asked

ESS System configuration in order to exclusively energize loads using batteries

Hello everyone,

I'm trying to design a three-pahse inverter/charger (Quattros) system that can energize a certain amount of loads (with only energy from batteries) within a certain schedule. Outside of that schedule, it should be able to power the loads using the energy from the grid. Is there a way to configure an assistant to help with this configuration setup?

MultiPlus Quattro Inverter ChargerESSLithium Battery
3 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

shaneyake avatar image shaneyake commented ·

During the "only energy from batteries" time, Can the system be grid-tied or would you want it to completely disconnect from grid?

0 Likes 0 ·
Show more comments
1 Answer
Paul B avatar image
Paul B answered ·

The answer is yes as I think the below may do what you are asking

you would need to install ESS assistant and then set the grid set point to say 100watt or lower this would mean that the quattros would only take 100 watt from the grid at all times if it was connected and the SOC was above a set figure that is. or until the battery got to a low SOC that you set then it would supply the loads from the grid


then set the schedule charge to the schedule you want, you can set many schedules with different SOC charge levels.


hope that this is what you are after



1 comment
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

dzm9508 avatar image dzm9508 commented ·

hi Paul, thanks for your answer


If I use this assistant it asks me to already have a country code defined. I have only three options, but my country doesn't appear in that list. Is there any way to download my country's profile? I'm from Mexico

By setting the grid set point to a minimum number, would this let me power my loads or would the Quattros send an alarm of overcharge?

The idea is to power the loads of my system all the time by using this Quattros, BUT they should energize these loads during a certain period of time exclusively with batteries (Peak shaving). This Quattros would always have two energy sources: grid and batteries. During the battery usage time, the grid should remain just as a backup, because I'm looking for that peak shaving characteristic in my system.


thank you for your time!


0 Likes 0 ·