This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Where does the chassis ground go on the shunt?....line side (battery DC-) or load side (all DC- loads)?
Can't believe this isn't in any of the Victron installation documentation.
System is;
solar panel/AC shore power/vehicle battery can all charge the house battery via MPPT and B2B controllers; only want to monitor house battery not vehicle starting battery.
Chassis ground should be connected to the load side of the shunt so that any current going to or from the battery is measured by the shunt. In a non isolated set up the chassis ground will form part of the charging circuit and needs to be measurable.
