I have just completed installation of two Skylla-IP44 chargers (120 60hz VAC input……12/60 DC output). All is working nicely. Both units answer to the remote control and operate as a single unit. The problem is that the total AC input current is limited to 10 amps; meaning 5 amps to each charger… giving me a total of about 75DC amps output rather than the 120DC amps that the two units combined should be capable of. Scroll #34 on the set-up menu on the charger screen is where the input current limit is set. The charger unit will not allow an input current setting above 10 amps. Both chargers are set to the maximum limit of 10 amps. However, the remote panel also will not allow current limit setting above 10 amps.. and this means 10 amps total… to be shared by both chargers. I need to find a way to set a higher limit on the chargers as that seems to be where the remote panel is getting its information. Please help. Thank you!