This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
The most common operation on a mobile system is to control the multi - Off, On, Charge Only and Inverter Only. With a Cerbo Touch 50, it requires finding the multi and then into the switch section.
It would be great if the Multi switch control functions were available as a popup on the home screen. Simply touch the Multi icon and control the state by a popup selection.
Hi Gary, this screen has exactly those functions:
Enable it in Settings -> Display & language:
I think Gary means you can turn the Multiplus on and of or in charge mode from the home screen ?
Instead of going though the menu, choose multiplus and then enable charging, both or off.
Hi @Leverg, in above page you can do exactly that. Those three gray boxes at the bottom are "buttons".
The Control of my multi switch does not seem to work on my system from any screen. I can see this but can’t change the state.
(Currently I left the multi switched off because I’d did not have remote control)
Do I need to configure anything in the multi to enable remote control?
Hi Laurenceh in some systems you can’t switch the multi on and off, for example if you have a Digital Multi Control panel installed, or if you have a VE.Bus BMS.
See Cerbo manual for the exact details.
I considered adding inverter control to the "flow overview" (aka home screen). I had also considered setting AC input current limit as well. In the end, I decided a tap on the AC input tile to set current limit and a tap on the inverter to set it's mode would conflict with a swipe to change overview screens. The "tile overview" has a similar behavior in that a swipe on the bottom of the screen scrolls to a new set of tiles while a swipe on the top changes overviews so I may be overreacting.
