This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Do you have to run the smaller power supply cable directly to the battery terminal or can you hook it to any constant 12v terminal. Wasn't sure if this cable measures voltage of the battery bank or is just a simple power supply? Trying to avoid digging out a bunch of caulk to get the red wire outside the trailer....
It must be connected to the battery. It is used as power supply but also for measuring and calculation.
With respect, Mr. Lange - could you explain further on this design? If the supplied VBatt+ cable must only be connected to the battery positive to be measured, then one would assume that it's length (resistance) would be critical - yet, in the Smart Shunt installation manual, there is no mention or prohibition on extending this cable to reach the battery in question. If extending the VBatt+ cable is in fact NOT permitted, this would restrict the location of the Smart Shunt installation significantly, as the cable is relatively short.
My understanding of the shunt principle is that it is uses the voltage drop measured across the NEGATIVE connections to calculate current. How does the Smart Shunt measure anything through the VBatt+ wire?
It seems unlikely to me that connecting the VBatt+ wire to, for example, a battery switch post that is connected directly to the battery positive by perhaps a 1m length of 4/0 AWG cable, has any electrical effect at all on the function of the Smart Shunt.
