Hello if have a new Setup with an Cebro GX and the Touch 50. I connected both with the USB/HDMI Cable but the Touch only lights up for less than a second and then it stays dark. In the VRM Device List, the Toch 50 is not listed.
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
The Touch 50 isn't listed as a device in the Cerbo. It's basically a simple monitor with a mouse (the touchscreen).
You could try connecting the Touch to any other HDMI output. Such as a laptop with HDMI out? If that works, you'll know it's the Touch that is at fault. If that works, probably a faulty Cerbo
Hey tozz, thanks for your answer. I tried some ohter things. So at first i took an HDMI Cable and connected the Cerbo to my TV. And at that momenti got a Picture on the TV. Then i bought a 7 inch HDMI Touchscreen at the Internet. When i connect this to the Cerbo, it says "No signal". No i realy dont know what to do!
HiThebest, it can be also that the brightness of the cerbo is 0 , so now way to see it. Connect to the cerbo / VRM and try adjusting the brightness / adaptive sensor light.
https://www.victronenergy.com/upload/documents/Cerbo_GX/GX_Device_Manual-en.pdf
Michel
I don't think you can set the brightness to 0 so the display is completely black.
I will try this later today.
Edit: I just tested it and as I thought you cannot turn the display off by setting the brightness to 0. The display just becomes darker.
@Thebest_21 I think your display is defective and you should contact your dealer to get a replacement.
Additional resources still need to be added for this topic
26 People are following this question.