This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hello,
My victron mppt 100/50 in 12V mode says Nominal max is 700W, but down the bottom it says "If more PV power is connected, the controller will limit input power. "
What happens If I hook up 900Watts of solar to controller? & This is the full 900watts noon summertime.
Does it simple take in 700W & the rest is wasted/left? Will doing this damage the controller?
thanks
NO issue/problem at all with putting 900 watts on a 700 watt reg victron blue ort smart solar MPPT unit
The unit will only accept the 700 watts and the rest is left
WARNING do not exceed the max PV voltage of the regulator so as long as you stay well under (at least 10% just for a margin thats all)
Hi Paul, they recommend not going over the short circuit current rating which is 60A for my victron, by the looks when you increase solar wattage you inevitable increase short circuit current. For example with my 3x 300watt portable fold panels each have 22A short circuit rating, so does that mean the whole lot is 66A when wired parallel into controller? and thus over the limit?
I've had a similar question a couple of weeks ago and got told that as long you don't go beyond the max. PV voltage of your MPPT 100/50, which is 100V, you don't do any harm to them. The MPPT limits the output to its maximum current of like 50A (or what you have set via VictronConnect).
But I wonder why you want to hook up 900W to a 700W MPPT?. That sounds a bit odd because it's quite a waste of power. If it were for a tiny bit more of wattage, I wouldn't ask.
Hi Stef. Where it is useful is outside the optimal couple of hours in the middle of the day when panel spec sheets *might* get close. And there's actually many reasons for doing it - short cloudy winter days, shade, clouds, suboptimal panel angles, and it goes on. Extending the length of hours for charging Pb's is a biggie too.
It's not really a 'waste' of power if you're offgrid, more a saving of genny fuel, and getting what power you need over a longer day to largely look after your batts.
Like Sean sez, many experienced offgridders will design it in. 'Clipping' of pv output comes with the territory when you're charging batts, and is actually your target to reach..
There's deeper technical reasons for not going too far though, but I won't go there just now.
