question

artur-pata avatar image
artur-pata asked

Advice on how to remove Smart LiFePO4 battery lid

I'm having some issues with my 100Ah LiFePO4 Smart battery (no bluetooth signal, connected SmartSolar charger gave voltage as 4.2V) and I'd like to take a look under the lid. I've seen it's been done before (https://community.victronenergy.com/questions/20875/reconditioning-victron-lfp-batteries-cell-voltages.html), but there seems to be a chance of damaging the electronics as the goop rips off with the lid. Any advice? Would heat help soften the adhesive?

Lithium Battery
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
markus avatar image
markus answered ·

The lid is glued onto the battery. If you have a large flat screwdriver you can put it into the holes under the lid and just crack the battery open. Remove the battery poles first. The electronics sit on the top of the cells, not on the lid.

It is for sure never ever advised by Victron to do that, but if it is your battery, nobody can stop you from doing this either. Apply common sense!!!

But this will be considered as a modification and is therefore moved into the mod space here.


BR

12 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

artur-pata avatar image artur-pata commented ·

Thank you very much for answering, I certainly didn't expect it after this time. The holes on the side allowed access with multimeter to check the individual cell voltages, so I didn't need to take the lid off after all. 0.5V, 0.5V, 2.0V, 2.0V...

Next question is what could have caused this? I had miniBMS with load and charge disconnect wired in. No DC loads except for miniBMS itself, SmartSolar bluetooth module, SmartLithium bluetooth module.

0 Likes 0 ·
markus avatar image markus ♦♦ artur-pata commented ·

Most likely, this was caused by self discharge of the battery. If the battery is left alone for a longer time, with little state of charge, this can happen. But to answer your question more concretely, you would have to supply more context what exactly happened in your case and in which timeframe. You could try a rescue attemt to charge the battery cells with very little current until the cell voltages come back to normal, but with that little cell voltages (0.5V) left, the chances that this will work are small. But be very careful and apply supervision all times and if you have doubts, to do this yourself, don't do it. Damaged Lithium batteries are not the best material to play around with...

Even if that is going to work, battery cell chemistry has changed and the battery is not considered safe anymore.

0 Likes 0 ·
Show more comments

Related Resources

Additional resources still need to be added for this topic