In the configuration menu of the CCGX connected to a LYNX VE.CAN shunt, one can find a programmable relay:
Since the CCGX relay is already occupied by the generator control I wanted to use it for temperature monitoring in the engine compartment and, if necessary, for controlling a small antifreeze heater, since the CCGX relay is already occupied by the generator control.
(see picture above)
Unfortunately, there is no detailed description of contacts on the board for the LYNX-VE.xxx shunts. Where can I find the assigned relay contacts
.... or can I not read correctly again?
One of my wishes from VE:
A simple module (CAN or BUS) for contoling and switching to
Claus
p.s: One of my future wishes from Victron:
A simple, independent module (CAN o. BUS ) for defining, monitoring, switching a couple of external signals and states, like contacts, voltages and temperatures over VRM over CCGX/VRM.
