This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have a Quattro 48/15000/200-2x100.
I don't have a generator and appears as Generator N/A.
I think it grabbed the config from CCGX when it had as default generator on ACin2 but I did change it to Not Available because ACin2 it is not in use.
How could I make it refresh in the dashboard of VRM?
@Teun Lassche (Victron Energy Staff) I for one don't mind the generator being there, but if it's already there, I would appreciate information which AC-IN it is connected to. It doesn't look like AC-IN1 is above AC-IN2 all the time. Quite the contrary: no matter which input you connect the generator to, it's always shown below the Grid.
@JSJC this is now possible, if the generator is not configured as AC input it will not show up anymore
I just saw it in VRM, thanks for the update, now I feel like I am "better configured" and its prettier :)
@jsjc Thanks for your suggestion, I'll have it checked, thanks!
I have the same, and my setup looks like the screenshots in the thread. I also have AC1 as "shore power", AC2 N/A as above.
Hi Teun,
More than a suggestion probably a little bug, I think it should be pretty much like the PV widget, it dissapears if not in use. Well this one does not :S
Cheers,
Javier
Should be really nice if the Generator widget is not shown. In the device list there is also no Generator.. so why is it here?
Just a little thing.. the new VRM is very nice.
It seems that when there is no input to the Inverter it shows both Shore and Generator. As soon as there is a mains input it corrects itself.
Mine is installed on a yacht, and over the weekend when connected to mains it was just showing AC Input. As soon as I disconnected from show it showed both.
