question

offgrid avatar image
offgrid asked

VE.Bus BMS System on/off switch & fuse

Hi there,
In the VE.Bus BMS manual, the installation diagram for a Multiplus shows a
"System on/off switch" connected to the Battery + on the BMS
And it shows a fuse connected between the switch and the battery positive terminal
I have circled them both in green below:


I am wondering, for a 24 system:
* What would be appropriate gauge wire for these connections
* What would be an appropriate switch for this connection
* What would be appropriate fuse for this connection

Thank you in advance :)

BMSwiringfusesSkyllaswitch
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
Matthias Lange - DE avatar image
Matthias Lange - DE answered ·

The "load disconnect" output is rated at 2A an the "charge disconnect" at 10mA.
So you will be fine with a fuse at 2-3A an a wire of 0.75-1.5mm²(AWG 20-15).
The maximum wire size you get into the connectors of the BMS is 1.5mm²(AWG 15).

2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources

Victron VE.Bus BMS product page

Victron 3rd party BMS compatibility page

Additional resources still need to be added for this topic