Should DVCC allow the MPPT to charge when sun is available, even when the Multiplus starts a charge due to low SOC early on a sunny day?
I've found the Multi will still be in absorption and the MPPT will go to float, but decides not to bother with any output, even though it could.
If i turn the MPPT charge off and on (in Victron Connect) it will try to charge for a few seconds but quickly cycle through Bulk-Absorption to float and give no output.. Only when the Multi goes to float does the MPPT start charging.
I'm using DVCC, + Ignore AC, both MPPT absorption and float voltages are higher than the Multi's
Could it be overheating? Today was hot and the batteries showed a peak of 37 Deg C, or maybe an incorrect setting, I.e. reduce the Ignore AC charge to end after bulk, but that's not ideal until we have more solar?
Or a symptom of the MPPT adaptive charge, either way i thought DVCC should tell them both what to do, as the Multi decided to use the AC In mains to charge when there was enough sun to cover the end of the absorption phase :( ..?
Thanks
VRM link:
https://vrm.victronenergy.com/installation/62545/share/c76c4bf6