This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hello,
since november I got no values from my venus GX in VRM portal. Yesterday I visit my weekend home, where the venux GX is installed.
I can not connect to the device any more. I saw that the Venux GX hangs on stage 3 in the boot process (green led ligths up permanently. There is no WiFi and not Ethernet access posible.
Is there a procedure to flash the device new?
Or what can I do to solve this?
Regards,
Rainer
For everyone having the same problem: I reflash procedure for a venus GX is on the victron developer site: https://github.com/victronenergy/venus/wiki/bbb-user-instructions
Hi @RainerWoll
You can try this procedure:
https://www.victronenergy.com/live/ccgx:firmware_updating_pre_v2_00
if that doesn't help, please contact your dealer for a replacement.
Hi Daniel,
hm, the Venus have no buttons, so how to go on?
I have found this :
but the procedure was not so clear to me. I don't now what Image to use etc.
Hi Rainer,
not sure if this is of any help, but as a first step you could try to factory reset factory reset network settings and then keep fingers crossed that it will start up.
AFAIK there is no way for the Venus GX to boot from a flash device like USB or SD card.
Sorry to hear. Not sure if the updating procedure mentioned by Daniel will work for you (because you have a Venus GX and not the CCGX), but you could give it a try. Else I also think that that the unit must be replaced.
