This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi,
I got ve.bus error 17 on a single multi plus inverter. ( see https://drive.google.com/open?id=10JNO4of2wJyu3LPYIzx3hXrt-U0WUdCx) . This shouldn't come on a single device, so I updated firmware to latest one, but it didn't help.
What could cause this and how to fix?
@Tony G, what's the history of the device and under what circumstances did this error arise? IE, is this a new installation with new-from-distributor device, or is this an existing installation in which the error suddenly arose, or is this a new installation of a device that had been previously used in a different installation?
Since it's a "missing phase master" error, my assumption is that (assuming this is a new unit) the device was accidentally configured to be used in a parallel configuration, or if it's a used device, it had been previously configured for parallel operation.
I recommend connecting to the device and opening VE.Bus Quick Configure, which is part of the "VE Configuration Tools for VE Bus Products" available for download here if you don't already have them; select "Reset a Multi to Standalone Operation" and proceed as directed (see attached screenshot).
@Justin Cook Device is from an existing installation and suddenly this error appeared. I will try to reset multi to a standalone mode if it helps.
@Tony G It's definitely the first thing to try, given the nature of the error. Let us know if that fixes it!
I have the same problem on my unit, it has been installed for several years and worked fine, i went away and disconnected the incoming ac supply from it, the batteries have gone down to 11.9volts whilst away but now will not come out of this error. any updtes would be helpfull
Just got on a site where a Victron user has this same problem . Single Multi 24/3K inverter - Off Grid - Sudden problem after 4 years . ? Tried to disconnect all . reconnect but still same error 17 with Overload alarmm ( 0 loads connected) , Simplify batteries 100% full. Any update ? Has anyone found a solution ?
I've got the same problem.. 12/3000/120, single/standalone mode, latest available firmware, powered off grid far a couple of weeks, error 17.
Powered on and off, disconnected all inputs and outputs (battery, shore, L1 & L2),
Used VE.Bus Quick Configure to reset to standalone, still error 17.
Defaulted the unit using Mk3 usb and reprogrammed, still error 17
This unit is one of the older Multiplus 2 (no assistants) models and has worked perfectly for several years.
Surly this isn't some kind of built in obsolescence?
