question

mfred68 avatar image
mfred68 asked

Being off grid in ess mode

I noticed that while on grid in ess mode that I import and export quite a lot of energy, it sometimes jumps to several hundred watts at a time in both directions. My threashold is set to minus 30% and I've tried it at minus 50 and 60% but too much exports, if I go to -20% even more imports.

I've over sized my system to be more off grid than on grid.

I currently have 15kw of pv and 42kwh storage and a multiplus ii 10kva. We use around 15 to 20kwh a day.

I recently tried faking a grid power cut by turning off the grid breaker, and my system is working seamlessly as off grid with an ess configuration for 4 days now, this includes my enphase microinverter panels, they also still work off grid. (My enphase did not produce when I previously configured my system as off grid, not ess)

So here's my question. I want to keep my system running in this off grid mode in ess configuration, but if the batteries reach 100% or fall below 20% I want the grid to reconnect to export and import respectively.

Can the relay on the cerbo gx be used to switch a contactor in line with the grid supply on and off when the batteries reach a programmable soc? Or can this only be done with the multiplus relay?

Reason I'm asking if the cerbo gx relay can do this is because I need to use the multiplus relay to switch a different contactor for hot water at a certain soc.

Also is it damaging using ess mode with the grid disconnected? Just in case

ess settingsgateway relaygrid relay
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

1 Answer
nickdb avatar image
nickdb answered ·

I have been connected for 3 days of the last 4 months, that isn't an issue.

You can use node red to flip the inverter soft switch to invert only and back to on as required by SOC, really easy to do.

There are less flexible ways of doing this with assistants, relays etc, but nodered is easiest imo.

This would be a topic for modifications section however.

4 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

mfred68 avatar image mfred68 commented ·
This node red switching sounds interesting, though not sure how to do this. Where di I start, any instructions would be really helpful
0 Likes 0 ·
Show more comments

Related Resources

Additional resources still need to be added for this topic