Today I finished my Lithium battery install and updated the Victron shunt settings when I noticed the quick view voltage was different then the details page
Quick view shows 13.41v
Details page shows 13.22v
Am I missing something?
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Today I finished my Lithium battery install and updated the Victron shunt settings when I noticed the quick view voltage was different then the details page
Quick view shows 13.41v
Details page shows 13.22v
Am I missing something?
Since it is part of a smart network you would need to check if it is an artefact of the network.
TY, since I don't use the smart network, I'll remove it and try again
However, one would think the values would match either way
Point of the smart network is in case there is mismatch then it can be compensated for.
Glad you are sorted though.
BDH here...
When I connected up my batteries to complete the work, I wasn't feeling well and actually put both Pos and Neg on the same battery (correct posts...) , rather than the Pos lead on 1 battery and the Neg to the shunt from the other battery
After fixing that issue, now both quick view and details view read the same
Thanks all
Additional resources still need to be added for this topic
39 People are following this question.