This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi
When the sun is out and the solar carries on charging, the Pylontech batteries become 100% but then i get High Voltage alarm, and even thou the batteries are at 100% the solar carries on charging at a very small amperage, everything is run by the Pylontech BMS and i am using a Cerbox GX.
Normal if it is new. Basically there is a cell that is going high. You will notice the pack voltage is not high.
Load an advanced widget for the min and max cells and monitor from there.
Have you programmed with the 52v and 51v as recommended? (Even though bms has control?)
Hi Alexandra
Not programmed anything, should these voltage be set in the MPPT 450 or on the GX?
Hi
Just away on holiday and still getting high voltage alarm , I’ve done the settings on the rs mppt but still getting fault , high voltage, will this damage anything cause problems ?
I can’t do anything as I am out of the country
Hi @davidtudor,
There are instructions for how to manage this situation here in the Pylontech battery compatibility guide - https://www.victronenergy.com/live/battery_compatibility:pylontech_phantom#high_voltage_warning_or_alarm_shown_on_battery_status
It's best to manage it via the Maximum Charge Voltage override setting in the DVCC menu rather than the MPPT RS settings.
It can all be done remotely, I know it's a urgent sounding message but it is not rare, and you are on the right track to resolving it.
