This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I have installed Shelly 1PM gen 3 switch/energy meter to my water heater load.
Cerbo seems to have detected the device on the network, as new "Shelly" device has been shown on Device List. However, it is listed as "Not Connected", even though it is online and I can control it with Shelly app.
When I test the switch and turn it On or Off, there is no change to "Shelly" device in device list.
Is there some additional configuration required to make it work in Cerbo?
Strange, I'm running like 20 (unprotected) shellies and my cerbo never mentioned any of them.
The built-in driver from Victron is only suitable for the Shelly Pro 3EM. If another one is connected via Websocket, it will be recognised, but as the data from the Shelly is sent in a different format, the Cerbo cannot decode it.
