This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
The MultiPlus 12/3000/120-50 120V only has single ac input with a Cerbo GX monitoring it and my generator. I currently have a manual transfer switch to choose between shore power and generator power. I would like to be able to autotransfer the power source like a Quattro. Can the multiplus be upgraded or what product can I add to accomplish this.
Thanks :)
You can add an automatic transfer switch in place of the manual one. However, the MPII has no way of knowing what the power source is, so the input limit will still need to be changed. The Quattro version does this automatically.
Generators often don't fare well being switched with an ATS. With a load on they may not be capable of responding quickly enough, and the power gets rejected. Either by the ATS itself or the Multi. If the ATS and it instantly retries, a horrendous 'chatter' can result.
If the Multi, it will trip the AC input and retry a few seconds later. Enablng 'Dynamic Current Limiter' setting will soft-start the draw on the genset if this happens.
In either case, the Multi *should* continue on inverting to serve the load.
You could try it, just be aware of what might happen.
You can install an ATS and use Kevin Windrem's guimods with the transfer switch setup to automatically switch between shore and generator AC input limits. You can also use the GX devices generator control logic for auto start functionality.
Note that there's no guarantee that guilmods will still be supported under the new gui which is in beta test at the moment.
