EVCS: Stop charging when drawing battery current is too high

Hi all,

Using the EVCS in an off-grid setup. I was expecting the 'auto' mode to stop when the solar drops OR when other loads turn on & the drawing battery current is too high. However I notice that the car keeps charging and my battery is being discharged at more than 100A. (Which I don't want.) If I manually disable the charge and enable "auto" again it correctly says "waiting for sun".

Is this expected behaviour or am I missing a setting?

Thanks

2 |3000

Attachments: Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Lucian Popescu (Victron Energy Staff) ♦♦ commented · May 22 at 11:44 AM

Setting/general.
Disable it or reduce the time.

0 ·

1716378275107.png (26.0 KiB)

walter-widmore Lucian Popescu (Victron Energy Staff) ♦♦ commented · May 22 at 11:49 AM

Got it. Thanks. Any future plans on a "max battery discharge" setting?

I'll disable it because I don't want to exceed the -100A limit but I assume now it will constantly start/stop while discharging till (for example) -50A would be OK for a specified timeout.

0 ·

Show more comments