question

abner-grech avatar image
abner-grech asked

Why is the inverter on light flashing and absorption and float lights on?

After resetting the country code on my Multiplus 2, it is not accepting the mains. I have two identical Multiplus 2 and so I can cross check. One of them works perfectly and has been doing so for the last two years. When I connect the other correctly and set up correctly the mains on flashes for a few seconds and then stops and the inverter on starts flashing and the absorption and float lights are both on too.

Multiplus-IINot sure - Admin please assign or createfaulty multiplus 2
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
pwfarnell avatar image
pwfarnell answered ·

You need to download the Victron Toolkit app to your phone / tablet as this lists all the LED codes. See about half way down this page.

https://www.victronenergy.com/support-and-downloads/software

5 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

abner-grech avatar image abner-grech commented ·

I already have all the Victron software installed and I do connect to my multiplus 2 and I checked my voltages and frequencies and none of the LED codes answers what is happening to my Victron!!!

0 Likes 0 ·
Show more comments
abner-grech avatar image abner-grech commented ·

Mine is absorption and float and not absorption and bulk. I did reset twice and the same is happening.

Also I already highlighted that I have two of the same Multiplus. With the same exact settings one is working fine and the other since I reset the country grid settings is not accepting the mains.

The error you highlighted is not the same.

My error is blinking mains for a few seconds and then it goes on inverter blinking and on absorption and float steady lit leds.



0 Likes 0 ·
Show more comments
abner-grech avatar image
abner-grech answered ·

Dear Alexandra when an exactly identical and identically set Multiplus 2 is working perfectly on the same system then many questions are not that relevant.

Still the system is single phase and has a 5kwh battery attached to it. The firmware is the latest. and yes I have a GX which is saying relay test fault.

Can you advice how to do a factory default reset please?

2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources