Hi all,
Unfortunately I do not get to run communication between ET340 and Venus GX via the Victron USB to RS485 adapter.
I did connect as said Data +, data - and GND between ET340 and the RS485 adapter. The left led on ET340 stays green instead of blinking red as I would expect if communication was enabled.
On the Venus GX no energymeter is available.
No difference wheter or not I use a terminator or not.
Does there need to be sth. enabled in the Venus GX? I did enable ModbusTCP, is that relevant by the way?
Hope somebody can give advice how to search for the solution step by step.
Best regards
Sascha