This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Quattro 10000, Fronius primo 8.2-1, 3 Mppt's 250/100, BYD LVL 600Ah
System is set up to 240V but output jumps between 230 to 250. Found it because lights started flickering more and more.
It's like related with tv and pc but not always happening only couple of times in a day.
It has been working fine since 2020.
Made firmware updates but still the same output.
What assistant do you have to control the fronius?
Production limiting with frequency works just fine with fronius.
whats the DC voltage doing at the same time as the AC voltage goes Hi
maybe the a cell is going hi or LOW and the battery BMS is going open circuit and thus you may get a AC voltage spike before the hz increases.
if you turn the Fronius primo OFF does it still happen (ie does it happen during daylight hrs only ????
is something else coming online or disconnecting ie the generator
these are just some areas to look at.
DC voltage is stable like no cell difference at all. I tried it with Fronius off as well but still unstable Victron Out voltage.
You seem to be genuinely offgrid, Generator tile too. Yet you're using ESS when it's manual states..
There's an alternative Assistant for offgridders.. https://www.victronenergy.com/live/assistants:pv-inverter-support
This should actually work better than ESS in your application. Have you tried it?
After change ess to pv assistant it's a little bit better but still not good enough.
It looks like the reason was still the last update from fronius, sometimes it worked fine but it had some disabilities.
Support made a downgrade of the firmware.
Now it's been working three days like a charm, hope that's solved now :)
