question

groningen avatar image
groningen asked

Quattro Temp sensor (T-Sence) - Only plug and play or should it be activated

An old install (10+ years), I have connected recently the temp probe via T-Sence in the Quattro.

Is it a plug and play only, or should I do some configuration in the CCGX?


Temperature Sensor
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
Alexandra avatar image
Alexandra answered ·

@Groningen

Plug and play.

It will show battery temperature under the inverter in device list.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

groningen avatar image
groningen answered ·

@Alexandra


Thank you for the reply.

Ok, should I do also a "calibration" on the Quattro (the same as I did on the Multi earlier today i.e. Superuser)?

Also, this would mean that the quattro will use this temp value during the charge cycle?


2 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Alexandra avatar image Alexandra ♦ commented ·

@Groningen

In the inverter itself (since it was designed for there) no there doesn't need to be a calibration.

I still check though.

It is used for temp compensated charging in lead acid systems and low cut off for lithium.


1 Like 1 ·
groningen avatar image groningen Alexandra ♦ commented ·
@Alexandra


Ok, thank you very much and thanks for the support, much appreciated.



2 Likes 2 ·

Related Resources

Victron temperature sensor disambiguation table - which product supports which sensor