Good day
I have recently Removed a 48v Steca inverter charger and replaced it with a victron system comprising of 4x 265 amp hr agm batteries as well as a 150/30 Mppt regulator and 4x 280 watt solar panels and a BMV702
I have go back to 24v with the new Multiplus II and wired this to 2x sets of 24v batteries these cables are of same length, and go to a post, and then from the post I have a 400amp fuse.
I configured the Multi with Ve config and the unit will not exit equalization mode and stays on for hours so i have then tired splitting the battery bank up with no difference, the Mppt SHows the batteries are in float but the multi just stays in equalization mode and ideas of the problem?