This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hello, I have an active input connected to the Multiplus II but the multiplus does not read the input current. It does read the input voltage and output current. See image below:
Why could this be? Could it be that the current transducer is broken?
Best regards
Has it connected (closed its relay) on the input?
How is it programmed? With virtual switch (ve config) or maybe Conditional AC connect (Victron connect)
A simpler check on the GX under
devices list - inverter - switch state
and see if it is 'inverter only' set there.
Do you have the external CT? Is the inverter set to use its internal metering system is system set up?
I have checked the configuration, and yes, it is set to use its internal metering system. Here the configuration:
Still not resolved.
have you check that the at wire link is in place on your multi plus-II look ware external CT wired for wired remote CT or if you have older multi plus-II with plug in type CT contact your Victron suppler for help as older multi plus-II with plug in type CT had problem with CT socket
We had the same issue with our Multiplus-ii configuration and it turn out to be caused by a faulty external current jack on the unit. New units have an audio jack, older ones had a terminal block to connect an external current sense coil to. When nothing is plugged into the jack, a set of contacts close to tell the Multiplus to make use of its internal current sense. Some other users found that by inserting and removing an audio plug several times would result in closing this connection again. This did fix our issue, and I would like Victron to create a jumper plug to ensure this problem doesn't repeat in the future.
