Hello everyone ,
Is there a gui mod that can show the relay control via temperature on the main display?
asked
Gui Mod for Relay Control via Temperatur
If a relay is set up for temperature alarm "Temp" should show up for that relay. No buttons would be enabled.
that's too bad. Can you let me take up your work Kevin...please
It is working here already as shown here for my Cerbo
If it is not, give me some details and I'll look into it.
Note: only relay 1 and 2 support setting to temperature alarm.
Thank you Kevin for your feedback.
My cerbo shows that only relay 1 supports the temperature. The circuit works via ruuvi sensor. “Overview” is also activated in the settings but there is no display on the main display.
Another error is that after restarting the system, the circuit is inactive and can only be started manually.
What data do you need for help?
CCGX, Venus GX and CANvu GX only have one relay. Please confirm what GX device you have.
If relay 2 appears in the Relay menu there is no way you don't have a Temperature selection. So please explain in more detail what you are seeing. A screen shot would help.
The relay page need to be enabled in Settings / Display & Language /Gui Mods. Show Relay overview must be on to see the relay Overview page. If you are not seeing this selection or if you aren't seeing the Gui Mods menu, then uninstall and reinstall Gui Mods and check again.
Unfortunately, that is not possible. The on/off selection is for each temperature device. So if you have two temperatures assigned to one relay there are two separate on/off selections.
I have 2 temperature settings on relay 1 but no selection in the overview
That is correct. I can't put an on/off in the relay overview because there might be more than one temperature associated with the relay. That's just the way it is and will always be.
So if you have two temperatures assigned to one relay there are two separate on/off selections.
You yourself wrote that at 2 temperatures two on off switches appear. Did I misunderstand that?
No, I said that two on/off switches would be needed. There is no space for additional on/off switches.
