This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I want to select input current limit on my Multiplus to other levels than the standard 
Image CaptionI experience some strange behavior. A few times I have been able to select 5 or 7, but in most cases I get the message 
. I get this message even when I select 3A
What is going on?
(Question rehrased on inspiration from Alexandra)
Can you please make some bigger screenshots so we can better see where you are trying to change the settings?
What MultiPlus do you have?
That adjusts the input current limit from shore connection.
You have to use an MK3 to usb adaptor and victron connect to change the battery charge current. Although to some degree it is affected by input current limit.
I want to control the "Input current limit" to protect my source, and as a consequence that influence charge current.
The source in this case is one of three
- Electric Car (EV) via an inverter
- My old to be decommissioned 24V Multiplus
- My Honda 5500W generator
Sure Matthias - I believe I have tried all variants - I have a Cerbo GX:
- VRM
- Remote Console
- Directly on local IP-adr (screen shot)
I think they behave the same way but I am not sure.
In the direct IP metode shot above I try to lover from 6.0 to 5.5. When pressing "Enter" the value change back to 6.0 - No warning or message
While using Remote cons
ole or VRM I do get the warning message screenshot for yesterday.
Right Now the strange thing is that VRM thinks that Input current limit is set to 3.0A while the Cerbo displays 6.0A - Screenshot below:
I changed back to 10A - Works fine - tried to change back again to 3A and got this message:
Multiplus-II 5000W 48v 230v AC
Brand new firmware 507
Thanks JohnC - That does explains the bottom 6A setting
