This is brand name 6/3 triplex wire, which is manual spec to handle power assist loads.
The strain relief does not fit.
What am I doing wrong?
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
This is brand name 6/3 triplex wire, which is manual spec to handle power assist loads.
The strain relief does not fit.
What am I doing wrong?
*Zip Ties are a temp solution
Its a Multiplus II 2000 80. The cable is 6/3 marine triplex.
The manual specs 6/3 wire. So, ... wire size is correct.
Try paring back that outer sheath so the individual cables can lay flat. They're the ones you want to clamp, not the whole assembly.
They also do not fit flat into the strain relief. The strain relief is only wide enough for two of them.
If flat, the cables span the entire width of the strain relief including the nut and bolts.
89 People are following this question.