With the new version of the multiplus 2, I was under the impression that you could program it to use battery to a certain state of charge? Is this correct? And is this even when the grid is not available?
asked
Can Multiplus 2 ACout 2 be programmed to open on state of charge?
In the programmable relay 'Switch Conditions' tab select 2 options to control the programable relay (AC Out 2) - 'AC Input' and 'State Of Charge'.
It should then act if either of the 2 conditions are satisfied.
An ON condition also has priority over an OFF condition.
Hi @Dylan
This is correct, you can program it with assistants to work as you want it to.
So is there a special assistant i need to load to do this. Can it be loaded with the ESS assistant I have.
When I program the relay, as shown in the picture. It deativates AC-2 out even if the grid is available. Is there a way to program it to only do this when there is grid failure?
