Whats the recommended way to connect these?
My thoughts atm are:
MPPT directly to Pylontech, VE.can to Cerbo gx
Pylontech to Quattro and ve.bms to Cerbo gx.
Quattro via VE.bus to Cerbo gx (get error see other topic)
Any suggestions?
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Whats the recommended way to connect these?
My thoughts atm are:
MPPT directly to Pylontech, VE.can to Cerbo gx
Pylontech to Quattro and ve.bms to Cerbo gx.
Quattro via VE.bus to Cerbo gx (get error see other topic)
Any suggestions?
In the end I used Bush bars as this is recommended although I never was quite clear why exactly even in this specific case.
Hi @Hans
I personally go all to the GX device, but I think this link explains it for you:
The pylontech to quattro might be the cause of your other errors.
All communication is going trough cerbo gx atm
Additional resources still need to be added for this topic
43 People are following this question.