question

André Jerleke avatar image
André Jerleke asked

Discharge and charge, not going lower than 98%

Hi! Anyone having a good idea on why the ESS in not going below 99/98% and under load discharge and charge instead of taking the load from battery, see video then you see what I mean. Ess is set to optimize without battery life, and set point is right now 6000w but I tested alot higher and even negative values on that, still just pending on 99/98%


setting.png

ess settings
8 comments
2 |3000

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Alexandra avatar image Alexandra ♦ commented ·
What is your grid set point?

Where have you told your meter it is installed?


0 Likes 0 ·
André Jerleke avatar image André Jerleke Alexandra ♦ commented ·

@Alexandra "Grid Setpoint" in Video is 6000W. Tested alot of settings but the same outcome.

"Where have you told the meter is installed?" -- Well "Grid metering" is as in image "external" or im unserstanding you wrong?


Right now im Running "Grid Setpoint" -11000W but still the same issue

0 Likes 0 ·
Alexandra avatar image Alexandra ♦ André Jerleke commented ·

Do you have a separate grid meter?

Feed from DC on?

0 Likes 0 ·
André Jerleke avatar image André Jerleke Alexandra ♦ commented ·

Im using Shelly 3EM to measure the grid load since battery,multiplus and PV are located in another building. Tested with Energy Meter EM24 - 3 phase but didnt see any difference to switched to Shelly.

Has DC System is off, see below (if you meant DC-coupled PV - feed in excess its also off, only AC-coupled PV - feed in excess is enable)

systemsetup.pngvictron1.pngess.png

0 Likes 0 ·
systemsetup.png (24.3 KiB)
Show more comments
0 Answers

Related Resources

Additional resources still need to be added for this topic