Hoi @mvader,
I think i've found a bug...
If you place colorgx - quattro - input current limit (AC current) on example 20A
And on the colorgx - settings - system setup - maximum charge current set on 8A
= limit is than 8A to battery and thats ok
AND then you go to colorgx - quattro - advanced - system reset (press to reset) OR you go to colorgx - quattro - switch (on to off and back to on)
Then there is no system check to what current is setup in ESS mode, it charges with full power setup in colorgx - quattro - input current limit ( 20A)
At that stage you can go back to colorgx - quattro - input current limit (AC current) and change to higher value or lower, system is following that value and not ESS value..
ALL is back OK when you hard reset the quattro with front switch to OFF and ON again. And in colorgx - settings - system setup - maximum charge current go from 8A to 10A and back to 8A.(just change value to something else)
Iam using all the last firmwares
All setting are made in colorgx, not in ve.config
AND colorgx - setting - ESS - mode set on "keep batteries charged"
Edit2: no solar attached, only grid
//kg
