This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I've set in Venus OS automatic start if voltage drops below certain value and it doesn't start even if voltage drops 1V below set parametr. Fortunately it can be triggered on inverter output power set, I assume the automatic start / stóp function works but not with voltage parametr.
Please advise FW version that you are running on the venus it should be 2.31 ???
if its not then please retest.
I am not aware of a problem in this area as I also use voltage to start and stop my Generator via the Venus relay and this is working correctly for me. I am using Fw 2.31
Check your delay start setting
My Venus runs on 2.31. Reset didn't help neither.
During these settings battery voltage was below 12.5V for a whole night.
You dont seem to have any battery monitor selected so how can it read a voltage ???
OR
You have do not run generator when ac1 is in use.
so the generator will not start if there is any AC on the AC1 in
even if its turned off by the inverter due to bad feed in or some other power issue or ignore AC1 in.
So have a look in those areas and see if thats of help
I don't have a battery monitor installed but Venus reads the voltage from Smart Solar MPPT connected via VE.direct. Please see the screenshots:
There is no power at Multi input AC1. Please keep in mind the gererator starts automatically when there is AC load triggered.
It may do that as you say but the Autostart generator feature only uses the Battery monitor as its source of input as par as I know.
@Jeroen, can you confirm: Venus can't use MPPT (Smart Solar) battery voltage nor VE.Bus (Multi) voltage to trigger Generator start
