question

udou avatar image
udou asked

ESS / DVCC - Maximum Charge Voltage

Being new to this forum, I did not find an answer to my question / issue and hope somebody can help me.

TL;DR; What can I do to prevent a MP2 to discharge a fully charged battery when I lower the DVCC Maximum Charge Voltage?


I am having a pretty standard ESS setup with 1 MP2 and a Seplos Lifepo4 battery.

As I understood that DVCC doesn’t work perfectly with the Seplos BMS as the smart BMS (meaning the system always charges to DVCC Maximum Charge Voltage, but unfortunately never drops to a float voltage to ease battery degration).

So I worked a bit with NodeRed and have a pretty good looking setup, which automatically lowers the max charge voltage when the system reaches the bulk voltage. As described, immediately after lowering the max charge voltage, my MP2 discharges the battery till it reaches the new voltage instead of just lowering the voltage and let the LIFEPO4 batteries lower the cell voltage on its own.

Can anyone help me tweaking it so the MP2 doesn’t discharge my battery?


Many thanks in advance!


DVCC
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

3 Answers
udou avatar image
udou answered ·

Btw all components on latest firmware except MP2 - there I have v497

6 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

klim8skeptic avatar image klim8skeptic ♦ commented ·

@UdoU have you checked out Andy's videos?

0 Likes 0 ·
Show more comments
nickdb avatar image
nickdb answered ·

If you force the system to drop the DC bus voltage beneath what it is actually charged to, it will naturally discharge, that is how electricity works.

Some batteries will set the CCL to 0.

Ultimately DVCC will do what the BMS tells it to do.

The max voltage parameter is not meant for ongoing use, it was implemented to help new batteries balance, and primarily for pylontechs which were more prone to issues on new installations.

If you want to change charging behaviour, the best place to do this is inside the BMS profile.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

udou avatar image
udou answered ·

Would the discharge also happen without DVCC when the MP2 goes from Absorption to Float? I don’t think so actually.


The BMS will not change any Voltages in any situation, therefore my attempt to mimic a float state for the charger

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

Related Resources

DVCC chapter in GX manual