question

grzegorz-gierszewski avatar image
grzegorz-gierszewski asked

The battery discharges with a large current when the BMS stops charging

Hi, I have 3 phase system Quattro-II with emus BMS, 3 x MPPT and PV AC inverter. Many of my systems with emus BMS works good but I have problem with one of them.

After fully charged, emus BMS disable charging and then batteries drain to grid with full current 280A. The same is when the BMS is charging and I manually disable the charging in the BMS. Batteries are immediately discharged into the grid without control. DVCC is enabled. It is only works good when I turn off DC-coupled PV feed in excess. Then after stop charging its ok.
In other systems with emus I don't have such a problem.

Regards

BMS
2 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

jack-stevens avatar image jack-stevens commented ·
Hey!


I am having the same issue currently, did you end up finding a solution?

Thanks,
Jack

0 Likes 0 ·
Show more comments
3 Answers
josmeijer avatar image
josmeijer answered ·

You don´t have by any chance D-bus serial battery driver installed? I just posted this on the GitHub forum, as I have the same mysterious battery dump after installing.


<After finally (after some bumps) finishing the installation of Dbus SB I found that a sudden Grid feed-in of >4000w was taking place.

I just installed dbus-serial battery drivers and did not change any other parameters.
I allways have AC and DC grid feed in switched on. I was forced to switch them off to avoid a total drain of the battery (I presume)
There are no alarms or messages.
Screenshot_2023-04-27_14-28-23

**VenusOS 3.0

  • Device type: Color Control GX
  • Firmware Version 3.0~36

**Battery/BMS

  • Daly 250A smart BMS
  • Cells: 16 LiFePo 250 Ah
  • Interface: USB-RS485 (factory standard DALY) >



1682626453224.png (173.4 KiB)
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

pvnic avatar image
pvnic answered ·

Is there an answer to the Problem ?

My Emus Control Unit set Status Charging Finish and the MP are drain to the grid with 280 Ampere. After Reset the Control Unit its okay.

2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

kevgermany avatar image
kevgermany answered ·

First thing to do is to move to the latest Venus, currently 3.3.

1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

pvnic avatar image pvnic commented ·
Thank you, It is on 3.3
0 Likes 0 ·