Not really a question but more of an update. Received a new unit and when I connected the Victron Connect app to it, it required an update from V2.11 to V3.00. Clicked "Continue" and was asked to input the device PIN number. The app suggested 0000 or 1234. Did this and the updated failed due to a failure to connect to the device. Ended up re setting the PIN code using the PUK code on the back of the device. The app confirmed that it had reset the PIN to 000000 - a six figure PIN. Just be aware it is a 6 figure PIN code in these new units, and you should use 000000 as the default and not just 0000 as that will fail.