Hi Victron community,
Is there a way to interface the Lynx Smart BMS 500 with an EasySolar-II GX? Is this possible via the VE.Bus port on the EasySolar? I have two Victron 12.8V smart Lithium batteries in this system.
Thank you for your help,
Aaron
asked
EasySolar-II GX with BMS-Can and Lynx Smart BMS 500 with VE.Can
Provided your EasySolar-II GX has a fully featured VE.Can port - see footnote 23 in the Victron GX product range overview - then yes. If it is has a BMS-Can port, then unfortunately not.
Do not try to connect the Lynx Smart BMS to the EasySolar's VE.Bus port. VE.Bus is exclusively for VE.Bus devices.
Hi Stefanie,
Thank you for your fast response! Bummer :( It looks like I received the older version of the EasySolar.
Is the VE.Bus BMS V2 unit my best option given that I only have VE.Bus and BMS-Can connections on my unit? If not, then what do you reccomend is the best product to interface my Victron lithium batteries with the EasySolar?
Thanks again,
Aaron
I would say yes. Considering its functionality, especially communication with VE.Bus inverters/chargers and a GX device, it is the best option. But in the end it comes down to your system.
Did you see the BMS Overview, which explains the main differences between all available BMSes?
Hi @Stefanie (Victron Energy Staff) Apologies, I missed your response in the tiny 'Show' link.
Yes, I have looked through this BMS document. I am tempted to keep the Lynx Smart BMS, purchase a Cerbo GX, and then run the whole show that way. This probably sounds a little nutty since I'll have two GX devices, but this would allow me to keep the battery health information that the Lynx offers, which is of interest to me for this project.
Does the attached diagram make sense? Thanks again for all your help. I really appreciate it! -Aaron
Diagram is looking good - except for the VE.Direct link between the BMS and the EasySolar and the VE.Bus terminator.
- You must disable the GX card in the EasySolar as you can only have one GX device per system. And with that, it also loses its VE.Direct connectivity. That link wouldn't make much sense either, since Cerbo and EasySolar are already talking to each other via VE.Bus. So how to disable the GX card? I'm afraid I don't know, but it's most likely in the manual I would think. If not, feel free to ask again.
- The VE.Bus is not terminated.
Hope this helps.
I'm happy to say everything is working great now with the Cerbo GX! Here is what I did:
1) Removed the facepanel of the EasySolar.
2) Disconnected Power, VE.Direct, VE.Bus from the internal GX Board.
3) Connected both VE.Direct from the internal MPPT 250 and VE.Bus from the internal MultiPlus II Inverter to the Cerbo GX. I used one of the exterior VE.Bus jacks for the inverter.
4) Connected Cerbo GX power to the AUX connection on the Lynx BMS
Thanks again Stefanie for all your help!
My project is coming along nicely with all this awesome Victron equipment :)
