This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi, I have a pylontech us5000 48v/5000 connected with cerbo gx and a smart solar mttp charger connected by ve.bus .
I have also a 5000w made in china inverter without any bus (it has only 4 line, 2 for battery connect and 2 to output 220v) and i have an old victron phoenix inverter without bus. Can I connect Pylontech battery to my inverter only using Vcc e Gnd Lines?
Not supported.
Is this for a data connection?
You realise that the Pylontec should only have comms with one system?
If you want the system to switch off the chinese one, why not use a relay from the cerbo?
Thank you Alexandra,sorry for my bad English,i explain my question, i don't want monitor any communication between my made in cina Inverter and Pylontech battery.
I want Pylontec communicate only with cerbo Gx and Mppt Smartsolar. Can i do it?
In this specific case, is data communication between Pylontech and the inverter mandatory or can it be avoided? Thank you
Yes with the cerbo directly. It can connect see the victron Pylontec page.
The US 5000 use the type a cable from victron.
