Hi my ESS uses Grid for no reason. Someone has an idea?
My system:
CerboGX
EM24
1x MP2 24/5000
8S3P custom Lifepo4 Pack with jkbms
My Grid setpoint is 80W
The room temp where the MP2 is is 27C
This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
Hi my ESS uses Grid for no reason. Someone has an idea?
My system:
CerboGX
EM24
1x MP2 24/5000
8S3P custom Lifepo4 Pack with jkbms
My Grid setpoint is 80W
The room temp where the MP2 is is 27C
where is this setting? In the bms its 200A but its not connected to victron.
And under DVCC i can only set charge current.
I also have seen 91A with my old 24/3000 MP2
Es muss ja einen Grund geben warum er genau diese 50A zieht und nicht noch mehr.
Der MP2 24/5000 könnte ja wohl viel mehr ziehen als diese 50 ?!
Also denke ich mal das die Ursache hier liegen muss.
Dein BMS ist nur passiv, es schaltet also nur ab oder zu?
Ist die Inverterleistung im ESS Menü auf 1500 W limitiert worden
ESS design and installation manual
Additional resources still need to be added for this topic
44 People are following this question.