Hi
I have an EasyPlus1600 12/1600/70.
It has worked without a problem until recently.
Now, it works as an inverter but does not charge the batteries anymore.
I am using it in my boat to charge the domestic battery (300ah LiFePO4) and the starter battery (AGM).
With the mains connected, I have measured that I have 230V into the EasyPlus. However, when checking the parameters with VEConfig the mains looks to be about 130V.
The problem might have occured when the inverter was accidently switched on with a kettle connected. The kettle is rated 2000w wich is more than the 1600w the EasyPlus can provide. I assume that the inrush current became large when the inverter was switched on. The domestic battery BMS did trip and disconnected the battery. The discharging overcurrent protection is set to 150A. I have checked the DC-fuse inside the EasyPlus and that is not the problem. Another thing that puzzles me is that when my remote Control - VE.Bus Multicontrol (on/off/charge only) - is set to off the low battery led is lit.
If anyone can help me understand how to get my charger going I would appreciate it very much! Thanks in advance.
Here are screenshots of the rest of the parameters.
Here is a photo of our boat a few days ago.
