I just installed an Easyplus inverter/charger, initially the fan ran a lot. Today I updated the firmware to enable the VE Bus Smart Dongle to see the Easyplus. Now the fan only runs when there is an overload condition. The smart dongle gets heat warnings, but the fan doesn't come on. If the inverter is overloaded, the fan will come on and run for a few seconds after the load is removed. The unit seems warm to the touch and the ambient temperature is over 30 deg C.
Is this normal with the latest firmware? I see in the firmware log that changes were made to reduce the fan run time after my unit was built. Firmware was 2606v154 and is now 2606v433