I have Nissan Leafs 48 volt - being wired to Busbars
Screen Shot 2019-04-06 at 1.42.18 PM.png
I am trying to place the +B1 and +B2 wires in the best place using the Battery Monitor / Shunt / Temp Sensor.
I am adding additional batteries to the bus bar later and wanted to keep adding them to the bus bars with same cable sizes.
Where would be a good place to install these 2 wires from the shut in this diagram?
I see the midpoint diagram that came with the Battery monitor, but I have 2 - 48 Volt cells instead of the diagram in the brochure that appeared to be wired using 12v cells.
I will be wiring up 4 total Leafs as extra budget allows until I find my ah requirements met.