This site is now in read-only archive mode. Please move all discussion, and create a new account at the new Victron Community site.
I don’t require a Lynx Power in, so I am attaching the connections from the Battery directly to the busbar ends on the Lynx Smart BMS At the other end from the Lynx Distributer.
Has anyone found an elegant solution to insulate the connections from accidental short?
Can’t come up with a better solution than winding with electrical tape at the moment, and that is hardly elegant.
Adhesive lined heat shrink tubing.
Amazon uk has decent sizing.
Measure the size of your bolts, I also dont know what you are using there. But the sizes are available.
I did it like this:
I found them in a local webshop. Sure you can find something similar.
And I had to cut them a little bit so they fell nicely over the busbars.
