question

sweyn avatar image
sweyn asked

Insulated exposed busbar ends on Lynx Smart BMS

I don’t require a Lynx Power in, so I am attaching the connections from the Battery directly to the busbar ends on the Lynx Smart BMS At the other end from the Lynx Distributer.

Has anyone found an elegant solution to insulate the connections from accidental short?

Can’t come up with a better solution than winding with electrical tape at the moment, and that is hardly elegant.

lynx distributor
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

2 Answers
Alexandra avatar image
Alexandra answered ·

@Sweyn

Adhesive lined heat shrink tubing.

3 comments
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

sweyn avatar image sweyn commented ·
Not sure where I can find heat shrink tubing large enough to cover the ends of the bus bars plus bolts and lugs?
0 Likes 0 ·
Show more comments
rikhf avatar image
rikhf answered ·

I did it like this:

20220707-135507.jpg


I found them in a local webshop. Sure you can find something similar.

And I had to cut them a little bit so they fell nicely over the busbars.


20220707-135507.jpg (1.6 MiB)
1 comment
2 |3000
Toggle Comment visibility. Current Visibility: Viewable by all users

Up to 8 attachments (including images) can be used with a maximum of 190.8 MiB each and 286.6 MiB total.

rikhf avatar image rikhf commented ·

https://www.uw-accuwinkel.nl/nl/aansluitmaterialen/accupoolklemmen/accupool-afdekkappen/accupool-afdekkappen-rs316-detail

0 Likes 0 ·