This would be really great to be able to add in Venus OS.... Look a lot like the Ruuvi but a lot cheaper but yet made by a pro company Teltonika.....
asked
Teltonika Eye Sensor (BT temp,hum) in venus?
I think it would be possible, the wiki is quite detailed, and by the look of it it uses bluetooth advertising, it's not until you want to perform advanced configuration or firmware updates you need to enter a PIN code to pair the device.
Thus in my mind, it should work, you would maintain the devices with the Teltonika app, and Venus OS would detect the advertisements...
https://wiki.teltonika-gps.com/view/EYE_SENSOR_/_BTSMP1
----
I've been looking into this subject myself for alternatives to Ruuvi or the new Mopeka sensors, I also use home assistant and when looking for support of these new devices using bluetooth advertising the most difficult part is decoding the advertisments as can be seen in the issues in this GitHub [repo](https://github.com/custom-components/ble_monitor), the Teltonika wiki link above includes this documentation...
I'd say there is only one way to try buy one and give it a go, I doubt the Venus OS would support these by default, and support would have to be added to the code from [this repo](https://github.com/victronenergy/dbus-ble-sensors) to support the different hardware, but maybe could be adapted from the existing Ruuvi code
I have few of these and also a Cerbo. These devices support iBeacon, Eddystone and "Sensors" protocols. I just activated Cerbo bluetooth interface. I'm not very familar with BT in general so what should I test?
Took the device close to Cerbo and logged in with ssh.
# bluetoothctl [bluetooth]# list [bluetooth]# list Controller F5:CC:D8:xx:xx:xx XXXXXXXXXXX [default] [bluetooth]# devices Device xx:xx:xx:xx:xx:xx xx-xx-xx-xx-xx-xx
That devices Device could be the Eye sensor, but its mac-address doesn't match.
[bluetooth]# scan on Discovery started [NEW] Device .... [NEW] Device .... [NEW] Device 7C:D9:F4:xx:xx:xx Name0002 [NEW] Device .... [NEW] Device ....
That's my device and bunch of others. Command info <mac> shows details of it.
I managed to get it 'trusted' but pairing via ssh didn't succeed yet. Cerbo console settings->i/o devices->bluetooth sensors doesn't show anything.
My wild guess is that even I'd be able to pair it at low bt-level, it would need higher level protocol support?
