Objective: Configure Multiplus only as a charger for lithium batteries
We are using:
-Cerbo GX
-Multiplus II 48/3000/35/-32
-DYNESS B3 48V - 3.6 kWh
Cerbo GX connected to Multiplus (VE.Bus)
Cerbo GX connected to battery (BMS-Can)
We have configured:
Settings > Services > BMS-Can port > CAN-bus profile > “CAN-bus BMS (500 kbit/s)”
Settings > System configuration > Battery monitor > “DYNESS-L battery on CAN-bus”
Device List > Multiplus-II 48/3000/35-32 > Switch > Charger Only
However, when we supervise on the remote console, it always indicates 100% at 49V and does not charge, we have maintained it for hours.
Any additional configuration that is needed so that the load percentage corresponds to the real one and the module works as a charger?